[. . . ] Dolby and the double-D symbol are trademarks of Dolby Laboratories. Precautions When Displaying a Still Image A still image may cause permanent damage to the TV screen Do not display still image and partially still on the LED panel for more than 2 hours as it can cause screen image retention. To avoid such image retention, reduce the degree of brightness and contrast of the screen when displaying a still image. Watching the LED TV in 4:3 format for a long period of time may leave traces of borders displayed on the left, right and centre of the screen caused by the difference of light emission on the screen. Playing a DVD or a game console may cause a similar effect to the screen. [. . . ] N Only when you set Anynet+ (HDMI-CEC) to On in the Application menu, the Device List menu appears. UMoveEEnterRReturn N Switching to the selected devices may take up to 2 minutes. N The time required to scan for devices is determined by the number of connected devices. N When the device scan is complete, the number of devices found are not displayed. N Although the TV automatically searches the device list when the TV is turned on via the power button, devices connected to the TV may not always be automatically displayed in the device list. N If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet+ function. Make sure to switch to an Anynet+ device by using the Device List. English - Anynet+ Menu The Anynet+ menu changes depending on the type and status of the Anynet+ devices connected to the TV. Anynet+ Menu View TV Device List (device_name) MENU (device_name) INFO Recording: (*recorder) Stop Recording: (*recorder) Receiver Description Anynet+ mode changes to TV broadcast mode. If a DVD recorder is connected, the disc menu of the DVD recorder will appear. If a DVD recorder is connected, the play menu of the DVD recorder will appear. (This is only available for devices that support the recording function. ) Stops recording. Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ (HDMI-CEC) is set to On in the Anynet+ Setup menu. Then press the TOOLS button to show the Anynet+ menu and select a menu you want. Press the SOURCE button on the TV remote control and select a device other than Anynet+ devices. Press P >/<, CH LIST, PRE-CH, and FAV. CH to change the TV mode. (Note that the channel button operates only when a tuner-embedded Anynet+ device is not connected. ) You cannot use the remote control when you are configuring Anynet+ or switching to a view mode. Use the remote control when the Anynet+ setting or switching to view mode is complete. You cannot use the play function when Plug & Play is in progress. Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu. If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord or a power failure, please repeat the device scan. Check whether the antenna jack on the recording device is properly connected. Connect the optical cable between TV and the receiver. I want to start Anynet+. I want to exit Anynet+. The message `Connecting to Anynet+ device. . . ' appears on the screen. [. . . ] both the conditions of the OpenSSL License and the original SSLeay license apply to the toolkit. In case of any license issues related to OpenSSL please contact openssl-core@openssl. org. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: . Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. [. . . ]